This post is on how to step-by-step replace Honda ECM/ PCM using VXDIAG HDS.
Tool to use:
Hardware: VXDIAG made by Allscanner Company
Software: HDS
HDS running at hardware VXdiag details at:
Installation:
Before start to replace Honda ECM/ PCM, you have to install VX Manager and driver which are stored in the CD-ROM, or you can browse http://www.vxdiag.net to download the newest setup files.
- Computer Requirements
Processor: Pentium 4/1.6GHz+.
Memory: 2G Bytes or more.
Hard disk: 40G or more.
Display: Resolution 1024x768 or higher.
Network interfaces: LAN 10/100M or 802.11b/g.
Communication Interface: USB2.0 or USB3.0
Operating System：Windows XP/Vista/Win7/Win8/Win8.1
- Installation notes:
Cancel open web page when HONDA HDS start
10 steps to replace Honda ECM/ PCM using VXDIAG HDS
1.System Selection Menu, click [IMMOBI]
2.Click [Replace ECM/PCM]
3.Press tick to continue
Obtain PCM-code from MaRIS2/GENPO/Distributor
4.Input PCM-code and Press tick to continue
PCM-code to use [Acura code Generator] calculated, you can buy it from ALLSCANNER Tech Co.,Ltd. Tel:0755-33000960
5.Turn the ignition switch off
6.Turn the ignition switch on
7.Turn the ignition switch off.
The registration of immobilizer codes into the Immobilizer unit has been completed.
8．Press tick to continue
Check all keys to ensure each will start the engine
9.Click [NO]
Is this vehicle equipped with a KEYLESS ACCESS Remote System?
10.The registration is complete.Press tick to continue
This is from CarDiag - Professional Car Diagnostic Tool Online Shop technical support: 10 steps to replace Honda ECM/ PCM using VXDIAG HDS
没有评论:
发表评论